Garage Projects

The Lone Ranger – Bronco II 23 Gallon Tank Swap

Since with the doubler in place, I cannot use the stock “coffin” tank that the rangers use. Here it is for a size reference:
Sara L.: Build and Misc &emdash;

I picked up a tank from Rock Auto for a fuel injected Bronco II. Fed-Ex beat the snot out of the thing before I got it, but it still showed up at my door pretty quickly.

I cleaned up the tank some and threw some rubberized undercoating on it:
Sara L.: Build and Misc &emdash;

After grinding off the rivets on the rear cross member, I then cut some slots in it for the fuel tank straps. I also took a guess at its mounting location:
Sara L.: Build and Misc &emdash;

Threw together a quick front support:
Sara L.: Build and Misc &emdash;

And stuck the tank in:
Sara L.: Build and Misc &emdash;

I liked how high up the tank was sitting, unfortunately, it was going to cause me some bed issues with the minimal body lift that I’m running. If one were to run a 3” body lift, this wouldn’t be an issue.

So back out the tanks goes, and I cut out the tacked in supports. With those out of the way, I notched the frame:
Sara L.: Build and Misc &emdash;

And placed the rear support back in, this time with some 1.5” spacers (the very back of the support is about 34” from the axle centerline):
Sara L.: Build and Misc &emdash;

Whipped up another support for the front:
Sara L.: Build and Misc &emdash;

And put the tank in its home:
Sara L.: Build and Misc &emdash;

With the tank lowered to its final height, I shouldn’t have any bed clearance issues, and my tank is still tucked up fairly high. Or at least, its not hanging any lower than it did on my Cherokee. From the lower horizontal surface (on the left hand side of the photo), the tank hangs down approximately 8”
Sara L.: Build and Misc &emdash;

I just need to add a skid, and get the fuel lines/power run to it now.

Long term note: I never had issues hanging up on the tank while wheeling, and the extra size was appreciated.

2 Comments

Leave a Reply