-
The Lone Ranger – Rear Bumper Air Tank
The rear bumper isn’t anything special, Just some ¼” wall 4×5 that Is capped off to be an air tank in the future (If I remember my measurements right, its about a 4 gallon tank size) . I took the center section to work and milled a hole for the receiver mount. After that was completed, I burned on the end caps and receiver: And burned on the truck: At this point I started playing with the side tubes some.…
-
The Lone Ranger – Stinger
I finally got around to finishing up the front bumper with the addition of a stinger. This took a little longer than I thought it would to get it to look right, but I’m happy with the overall results. Bent up a hoop and played around with the placement of it: So much for being able to walk around the truck with the garage door closed (and it only fits in the garage one way now): It was a little…
-
The Lone Ranger – Front bumper main structure
It was a bit of a road to get here, but I finally settled on a design for the front. Just to recap, I went through more than a few versions to figure out exactly what I wanted. Starting with V1 (Right) and V2 (Left): I then ditched those two ideas and started on the V3 with the main supports: Added the outer potions: Still wasn’t happy with that (seemed to big). So onto V4, I kept the same center…
-
Saying goodbye to the Cookie Cutter TJ
So the day has come where the Cookie Cutter TJ was sent down the road. I was at a bit of a crossroads where If I kept going down the road I was one, the TJ was going to get fairly built. This would have destroyed whatever value that it had as there isn’t much of a market for “Built” 4x4s. Also, with another kid on the way, the thing was just too small for us to load up and…
-
The Lone Ranger – Front Bumper Guessing
I started playing with some ideas for my front bumper tonight. I was having difficulty trying to figure out how to make the front bumper not seem retardedly huge. With the help of the wife, I think I’ve got a decent concept to work on. The issue is that I’m trying to meet IL lift law, which states 27” in the front for my GVWR. The lower part of my winch plate currently meets that: That’s cool, but as you…